To Next Page

To Previous Page

v130 – Marine Satellite Communication System

In “SETUP” mode, “Back Up Position” or “Restore Position” message will pop up

if “Backup” or “Restore” button is pressed. Backup File (*.ibf) and Report File (*.rpt)

will be generated on the PC if “Back Up to PC” button is pressed. You can open a

report le using notepad software.

NOTE: These two functions are only available for ACU Version 1.07 or later.

• Status

- Search 1: A search pattern 1 will automatically be initiated when the ship’s heading

input does not exist or is failed. The search cycle will repeat until the antenna

receives the lock signal from the modem or the DVB transponder of the target

satellite is decoded by the antenna.

- Search 2: Search 2 is reserved for future use.

- Search 3: Search 3 is a search pattern 3 will automatically be initiated when

AGC/SIG falls below the current tracking level threshold value. Once the desired

signal is found and above the predened tracking threshold, the ACU will enter to

tracking mode.

- Tracking: Antenna is tracking the target satellite.

- Initialize: Antenna or ACU is initializing.

- Setup: Antenna is in SETUP mode.

- Comm: Antenna is able to be communicated.

• Local frequency

- Local freq: Display LNB local oscillator frequency.

- Signal level: Display signal level. It shows “DVB” when DVB mode of tracking

signal is chosen to be used and “NBD” when NBD mode of tracking signal is

chosen to be used.

• System versions

- Product ant: Display antenna model and “PCU” rmware version.

- Product ACU: Display ACU model and “ACU main” rmware version.

• TX enable:

- TX enable: TX function is enabled and ready to transmit.

- Enable mode: Not in SETUP mode.

- Blockage: Antenna is not facing the predened block zone(s).

- Pointing: Antenna is pointing to the target satellite.

- Modem lock: Satellite modem is sending a logic input to the ACU to identify when

the antenna tracks on the correct satellite.

- LNB rotate: LNB is not rotating.

NOTE: The TX function will be enabled (shows blue dot) only if all of the factors listed above shows “blue”

dot. If any of the factors listed above shows “gray” dot or "red" dot, the TX function will be disabled

(shows red dot).

Exception: If “Use TX Mute” is set as “NO”, the TX function will be enabled regardless of which factor

listed above shows “gray” dot or “red” dot.

Intellian v130 User Manual

Questions and Answers: