Intermec EasyCoder PD42 User Manual

Chapter 4 — Troubleshooting and Maintaining the Printer
EasyCoder PD42 Printer User’s Guide 41
Label not taken. Printing has been halted because
a label is obstructing the LTS
sensor.Remove label to resume
printing.
LSS too high, LSS
too low.
These errors can occur when
you run a testfeed without any
media installed, or if you have
incorrect media settings.
Load the printer with media
(see “Loading Media” on
page 14). Restart the printer in
Test mode (see “Running
Testmode” on page 34) and
select the appropriate media
type.
IP Configuration
Error.
The printer is trying to acquire
an IP address from the network.
Wait for it to complete the task.
Display Error Messages (Error LED Blinks)
Error Symbol Error Message Solution
Field out of label. You are attempting to print in
an area that extends beyond the
“print window.” See appendices
C (Fingerprint) and D (IPL)
information on how to set the
media parameters.
Out of media. Load media in printer. See
“Loading Media” on page 14.
Display Error Messages (Blue Ready-to-Work LED Blinks)
Error Symbol Error Message Solution

Intermec EasyCoder PD42 Specifications

General

Brand	Intermec
Model	EasyCoder PD42
Category	Printer
Language	English