Chapter 2 — Connecting and Configuring the SR61T
12 SR61T Tethered Scanner User’s Guide
3 Connect the standard RS-232 cable to your SR61T.
4 Connect to the host PC.
5 If you are connecting to an Intermec computer, turn it on.
6 If necessary, configure your SR61T serial parameters to match the
PC.
The default serial parameters for the SR61T are:
For help, see “Serial Parameter Parameters” on page 20 or
EasySet version 5.6.0.1 or later. EasySet is available from the
Intermec web site at www.intermec.com/EasySet.
To connect with a powered RS-232 cable
1 Make sure you have a powered RS-232 cable (P/N 236-185-xxx or
P/N 236-198-xxx).
2 If you are connecting to an Intermec computer, turn it off.
Otherwise, leave the host PC on.
3 Connect the externally powered RS-232 cable to the SR61T and a
power supply. Plug the power supply into an AC power outlet.
Serial Parameter Default Setting
Baud rate 57600
Data bits 8
Parity None
Stop bits 1
To Next Page
Loading...
