Version 2.5 (11/2020) UL
Translation of the original operating manual 53 of 140
Start-up and operation
6.6 Operation
WARNING
Risk of crushing due to unintentional start-up of the RollerDrive!
¾ Before switching on the power supply, ensure that no persons are present in the hazardous areas
surrounding the conveyor system!
¾ In ZPA mode, all connected RollerDrives carry out an initialization run for a maximum of four seconds after
switching on the supply voltage!
When the MultiControl is functioning as an I/O device, it cannot start or stop motors or carry out other
actions independently. To do this, it requires commands from a higher-level control system, e.g. a PLC.
Check before every start-up
¾ Check all MultiControls for any visible damage.
¾ Check all protective equipment.
¾ Ensure that none of the RollerDrives connected to the MultiControl are jammed.
¾ Specify in detail how the material to be conveyed should be set down on the conveyor and monitor this to
ensure it is carried out correctly.
Take the ambient conditions into account during operation (see „Technical Specications“ on page 19).
Start
¾ Ensure that the ambient conditions are maintained during operation (see „Technical Specications“ on page19).
¾ Switch on the power supply.
¾ Send the corresponding signal to the MultiControl.
Stop
The conveyor system will stop under the following circumstances:
• When the power supply is switched o
• When no start signal is present
• When an error from a corresponding error class is present (see „Error Handling Settings“ on page 45)
To Next Page
Loading...
Need help?
General