Version 2.5 (11/2020) UL
Translation of the original operating manual 65 of 140
Decommissioning and disposal
9 Decommissioning and disposal
CAUTION
Risk of injury from following incorrect procedure.
¾ Decommissioning must only be carried out by authorised, qualied personnel.
¾ Only decommission the MultiControl when the system has been disconnected from the power supply.
¾ Switch o the power to the MultiControl and ensure that it cannot be unintentionally switched on again.
9.1 Decommissioning
¾ Remove all cables from the MultiControl.
¾ Loosen the screws that have been used to attach the MultiControl to the base plate and remove the
MultiControl.
¾ If the MultiControl is to be completely dismantled, also loosen the screws that have been used to attach the
base plate to the conveyor frame and remove the base plate from the conveyor frame.
9.2 Disposal
The operating company is responsible for disposing of the MultiControl according to correct procedure. In
doing so, the industry-specic and local provisions for disposing of the MultiControl and its packaging must
be observed.
To Next Page
Loading...
Need help?
General