54 of 140
Version 2.5 (11/2020) UL
Translation of the original operating manual
Start-up and operation
6.7 Procedure in the event of accidents or faults
¾ Stop the conveyor system immediately, switch o the power supply and ensure that it cannot be unintentionally
switched on again.
¾ In the event of an accident: Perform rst aid and call for the emergency services.
¾ Inform the relevant supervisor.
¾ Have specialist personnel rectify the fault.
¾ Only resume operating the conveyor system once this has been approved by the specialist personnel.
To Next Page
Loading...