Version 2.5 (11/2020) UL
Translation of the original operating manual 63 of 140
Assistance in the event of faults
No. Short text Comments
31 ApplErrErrorLogUpdate Access error to error log le
40 ApplErrPanellllMode Change of mode not permitted
41 ApplErrPanelLedBlocked Access to LED control not permitted
42 ApplErrInvalidApplConf Invalid conguration of the application program
50 ApplErrDriveError1 RollerDrive 1 error
51 ApplErrDriveError2 RollerDrive 2 error
52 ApplErrDriveError3 RollerDrive 3 error
53 ApplErrDriveError4 RollerDrive 4 error
60 ApplErrStateTable Error in the application program
61 ApplErrCtrlError1 Specic errors in the application program. Errors in the ZPA/ZPA+
programs are explained in the "MultiControl / RollerDrive - Start-up and
Programming" supplement.
62 ApplErrCtrlError2
63 ApplErrCtrlError3
64 ApplErrCtrlError4
65 ApplErrCtrlError5
66 ApplErrCtrlError6
67 ApplErrCtrlError7
68 ApplErrCtrlError8
69 ApplErrStartProgram Application program cannot be started
70 ApplErrSysRestart (Re)start of the application program/system
71 ApplErrPowerFail Voltage error: Supply voltage failure
90 ApplErrTemperature Temperature error: Temperature at the brake resistor too high
91 ApplErrLowVoltage Voltage error: Supply voltage (L1 or L2) too low
92 ApplErrHighVoltage Voltage error: Supply voltage (L1 or L2) too high
To Next Page
Loading...
Need help?
General