iteco IT 10122 - Emergency Stop Push Button; Flatness Indicator

OPERATING AND MAINTENANCE HANDBOOK
Emergency stop push buon
The red emergency stop push buon is placed both on the ground
control panel and in the platform control panel.
Pressing the push buon both from the ground control panel and
from the platform control panel, any movement and command of the
machine are disconnected, except for safety indicators (pilot lights
and audible alarm). In order to restore normal functions, pull push
buon upwards.
Only by turning the key of the ground control panel in the OFF position,
the machine is turned o and its safety functions are disconnected.
Flatness indicator
The microprocessor atness indicator is a digital device, placed in the
middle of the truck, able to control the maximum slope at which the
machine can work.
Should it is exceeds the allowable maximum slope, could cause:
•Under the SQ1 operating height, the inclination warning light on the
platform control panel blinks. If you want to reach a level above SQ1,
restore machine conditions in which warning light is o.
•All machine movements stop when SQ1 operating height is exceeded,
apart from platform lowering which is signalled by the switching on
of the inclination and danger warning light on platform control panel
(See platform control panel - position 16 and 15 and “Emergencies”
section) as well as by a sound alarm. For enabling movements again,
the platform must be completely lowered and the machine must be
put to a stable condition again.
The atness indicator must not be modied for any reason
IT10122 - IT12122