iteco IT 10122 - Machine Unstable; Protections against Overturning

OPERATING AND MAINTENANCE HANDBOOK
Machine unstable
PILOT LIGHT 16 When the truck is inclined above accepted limits the pilot light 16 is
activated:
When the scissor is closed (the platform is at a lower height than the
working height of SQ1), pilot light 16 ashes : if it is necessary to
li the platform , it is necessary to bring the machine back into the
stabi- lity conditions.
When the scissor is opened (the platform is at an higher height than the
working height of SQ1) the pilot light 16 ashes and an acoustic alarm
is activate, traction, steering and liing movements are blocked.
In order to restore movements it is necessary:
- to completely lower platform and bring the machine back into
the stability conditions.
Make sure that no obstacles are present under the platform before
lowering it.
Protections against overturning
PILOT LIGHT 18 The protections against overturning reduce the clear height of the
machine and increase its stability.
They are lowered when the platform lis and they are closed when
the platform is entirely lowered.
If an obstacle does not allow the protections to lower, the traction and
steering movements are stopped.
•The movement stopping is displayed by:
-the lighting-up of pilot light 18 on the control panel.
- an audible alarm.
• In order to restore movements it is necessary:
- to lower entirely the platform and remove the obstacle.
Pay aention when the protections are moved in order to avoid
crushing.
Should an obstacle doesn’t allow to sliding blocks to re-enter, a spring
compresses itself to nish the lowering without damage the mecha-
nism.
IT10122 - IT12122