iteco IT 10122 - Check Oil Level; Electrolyte Level Check; Check of Battery Charge

OPERATING AND MAINTENANCE HANDBOOK
Check oil level
The oil level checking and the possible topping up should be made
when the platform is entirely lowered
Take away oil tank cap being in the hydraulic control unit; should it
be necessary top up with oil of the same viscosity as indicated on the
tank.
Electrolyte level check
• Open the boxes
• Take away the electrolyte supplying caps
• Check the level and if it is the case top up with distilled water
• Close caps and dry if some liquid has poured out
The sulphuric acid contained in the solution could cause serious in-
juries; if it is unintentionally poured , wash immediately the objects
or the surfaces with abundant water.
If the acid comes into contact with the skin, wash immediately with
abundant water and consult a doctor.
It is recommended to always wear gloves and protective glasses dur-
ing the maintenance operations of baeries.
Check of baery charge
The baery charge level can be read on ground panel.
For the baery recharge see section “Baery recharge”.
IT10122 - IT12122