iteco IT 10122 - Check of Wheel Reduction Gear Oil; Check of Hydraulic Tubes

OPERATING AND MAINTENANCE HANDBOOK
Check of wheel reduction gear oil
•Move the front wheel on the horizontal surface having the two level
caps (pos. 1) aligned.
• Unscrew one of the two caps (pos. 1): oil must be ush with the
hole.
•If necessary, ll up with oil type SAE 80 W - 90.
•Total capacity 0.4 litres.
Check of hydraulic tubes
Hydraulic oil is a polluting product.
Avoid uid leakages by using collection tanks and take precautions
against accidental leakages by resorting to oil-absorbing products.
•Visual control of all hydraulic joints and tighten junctions, if neces-
sary.
•Check conditions of exible hydraulic tubes; replace if necessary.
1 1
IT10122 - IT12122