iteco IT 10122 - Load Limiting Device; Antishearing Operations

OPERATING AND MAINTENANCE HANDBOOK
Load limiting device
•Load platform with a load equal to 120% the nominal value.
• Check that by operating platform liing :
- the excess load warning light on platform control panel
switches on.
- the excess load warning light on ground control panel
switches on.
- the alarm sounds
- all movements are stopped.
•Remove excess load.
• Check that all movements are restored.
Antishearing operations
Make sure that there are no obstacles above or under platform before
carrying out this test
•Li platform by 2 meters.
•Lower platform and check that lowering is stopped when distance
between arm and frame ends is approx. 60 mm. Aer a time interval
of 5 ÷ 6 seconds, put the joystick in standstill position and continue
the lowering.
•Check that lowering remains inhibited even if you move the joystick
for the lowering before the indicated time interval has passed.
•Check that drive and steering movements are deactivated.
• Check that the protections against overturning pilot light on the
platform control panel and audible alarm go on.
•Lower the platform and remove the obstacle.
•Repeat the check on the other protection.
IT10122 - IT12122
•Li the platform above SQ5 operating height