iteco IT 10122 - Operations from Ground; Starting and Enabling Ground Controls

OPERATING AND MAINTENANCE HANDBOOK
Operations from ground
Controls enabling the operator to switch the machine on and operates
with the ground control panel are the following:
Starting and enabling platform controls
•Platform liing/lowering
•Other functions hereinaer described are:
•Emergency stop
Other functions hereinaer described are:
•Overload pilot light
•Baery charge indicator
• Hour-meter
•Diagnostic display
Make sure that the emergency stop red push buon on ground or
platform control panel is not pressed.
Starting and enabling ground controls
•Each time the machine is started up, the signal lights and audible
alarms are switched on to verify their correct running (pilot lights
and buzzer). Before using the machine, wait they are switched o.
•Insert key in selector 1 and turn le, keeping this position, in order to
put ground controls into operation (in this position it is not possible
to extract the key); the pilot light 6 goes on. If the key is released, it
returns automatically in the middle position (OFF), and the machine
is stopped.
1
6
IT10122 - IT12122