iteco IT 10122 - Platform Lifting;Lowering

OPERATING AND MAINTENANCE HANDBOOK
Platform liing/lowering
During movement, do not move selector 14 from traction to li ing
position and vice versa. In this case the machine stops. Release the
joystick 8 and give the command again to restore the movement.
With machine in stop position, move selector 14 right.
• Hold joystick 8.
• Press push buon 10 “Man present” and keep it pressed.
• Bring the joystick forward to li the platform or backward to lower
it.
The liing speed is adjusted according to the inclination given by the
joystick 8.
Before liing or lowering platform make sure that no obstacles are
present on or under it.
Always check the state of pilot lights ; in case they go on, please,
read section “Emergencies”
Liing stopping
Slow: bring gradually joystick 8 back into the starting position, keep-
ing pressed the push buon 10 “Man present”. The electronic control
device guarantees a so stopping.
Fast: release switch 10 “Man present”. The electronic control device
assures a quick stopping.
8
8
14
10
IT10122 - IT12122