DAILY 4x4 ‒ GUIDELINES FOR BODYBUILDERS
ELECTRONIC SUB-SYSTEMS
5.2 BODYBUILDER CONNECTORS
15
– Printed 692.68.999 – 3 Ed. - Base 08-2020
262204
Figure 11
Table 5.6
Resistance Values [Ohm] R0 R1 R2 R3
120 270 510 2000
230826
Figure 12
For this purpose IVECO recommends use of a relay (not identical to that
for the Cruise Control interface) which enables utilization of the same
functions available on the steering wheel lever.
The Cruise Control option must be configured on both the ECM and BCM
systems.
Please note that the driver must position the Cruise Control switch on
the steering wheel lever to OFF, otherwise the external controls will be
ignored.
Table 5.7
Function Short-cut necessary
ISC Mode 1 Pin 2 Pin 6
ISC Mode 2 Pin 5 Pin 6
ISC Mode 3 Pin 8 Pin 6
(10)
WARNING:
If the K15 Remote control was activated and the operator removed the ignition key with the engine running, the en-
gine would not stop and it would be possible to move the vehicle with the steering locked. Therefore:
To Next Page
Loading...
Need help?
General
