DAILY 4x4 ‒ GUIDELINES FOR BODYBUILDERS
GENERAL INFORMATION
1.14 IDENTIFICATIONS
11
– Printed 692.68.999 – 3 Ed. - Base 08-2020
1.14 IDENTIFICATIONS
Logos, identification trade names and nameplates must not be modified, displaced or removed since the original design appearance
of the vehicle must be safeguarded.
The application of trademarks relating to the transformation or outfitting must be authorised. They must not be applied near to the
IVECO trade names or logos.
In the event of cowl vehicles, the positioning of the IVECO logo on the engine bonnet must be done only after final paint spraying
and must respect the measurements indicated qualitatively in the following figure.
222674
Figure 2
1. Front view
2. Side view
a. Bonnet lower edge
For the actual measurements and for the realization of a possible template, please consult the design 5801620982.
IVECO reserves the right to withdraw its trade names and logos if the above requirements are not met.
1.15 DIMENSIONS AND GROUND
1.15.1 General information
The dimensions and masses of vehicles allowed on the axles are shown in the drawings, the technical descriptions and, more gener-
ally, on the documents on the official IVECO website. Defects refer to vehicles in their standard versions; the use of special equip-
ment may lead to changes on the masses and their distribution on the axles.
1.15.2 Vehicle adaptability
The body length limits mainly depend on:
● wheelbase length
● distribution of mass on the axles
● maximum permitted width
To Next Page
Loading...
Need help?
General
