Jay electronique ORRD22L1C - Transmitter Identity Code Programming Procedure

Gb Fr
324501D revision07 - 51 -
De
Transmitter and receiver are linked by a radio channel and an identity code.
During the «association» programming procedure, one or several relays of the
receiver(s) are going "to learn" the identity code of one or several transmitters.
This identity code is programmed on the transmitter, it is freely chosen by the user to
personalize its installation (256 possibilities).
The ORE transmitter is equipped with a 8 cursors 2 states DIP switch («ON» or
«OFF») to program the identity code.
3.2- Transmitter identity code programming
By default (in the delivery)
the transmitter identity code is : .............. ON-ON-ON-ON-ON-ON-ON-ON
We strongly recommend that you change this code to ensure
the uniqueness of your installation and avoid any unintentional
commands from another system which may already be
installed.
Standard transmitter (ORET)
and industrial (OREi)
Multifunction transmitter (OREL)
ON
12345678
(DIP switch, identity code
programming)