Gb Fr
324501D revision07 - 53 -
De
3- "Industrial" type receivers (ORRA and ORRS): switch ON receivers.
4- -
V2
and
V3
LEDs are blinking.
- The receiver waits for an identity code reception (pressure on a transmitter
function button) to auto-configure its relays.
5- Press on one transmitter buttons (it doesn't much matter which) to associate
transmitter with the receiver.
The receiver affects then automatically the transmitter buttons with its relays.
6- Once the programming procedure is finished ( 2 LEDs
and
V3
go off),
switch off industrial receivers (ORRA and ORRS) and remove jumpers
JP1
and
JP3
, or place
JP1
and
JP3
microswitchs in «OFF» position for receiver
(ORRD) on DIN rail.
NB = If no transmitter button is activated during this programming procedure, the
receiver parameter settings (buttons / relay association, interlocking and
operating mode previously programmed) will not be erased.
To Next Page
Loading...
