jcb Mini CX - Page 279

Section E - Hydraulics
Drive Motors
Wheel Drive Motors
E-109 E-109
9803-9340-8
865890A
Fig 23.
6 Install a new ‘O’ ring (045) and, on rear wheel motor,
‘O’ ring (057) K Fig 24. ( T E-109).
865890B
Fig 24.
7 Place a continuous bead of JCB Multigasket on the
brake housing as shown below
K Sealing and
Retaining Compounds ( T 1-29). Ensure there no
gaps K Fig 25. ( T E-109).
865890C
Fig 25.
The following steps must be carried out within 10 minutes
of applying the sealant.
8 Place the brake housing onto the cover and position
using some new screws
K Fig 26. ( T E-109).
865900A
Fig 26.
9 Install and tighten the remaining new screws (102) to
75-85 Nm (51- 63 lbf ft.)
K Fig 27. ( T E-110).
ðìë
ðëé
É·¼¬¸ ±º ¾»¿¼ æ
ë ¬± ïð ³³ Åðòî ¬± ðòì ·²Ã
Ó»¼·¿² ´·²» ±º ³±«²¬·²¹
½®»© ½»²¬®»´·²»ò
Ò± ¿¼¸»·ª» ·² ¬¸» ¹®±±ª»ò