jcb Mini CX - Page 290

Section E - Hydraulics
Drive Motors
Wheel Drive Motors
E-120 E-120
9803-9340-8
7 Install the bearing (073) inside its outer race
K Fig 72. ( T E-120).
866030A
Fig 72.
8 Position the shaft under a press and on a suitable
support to prevent damage to the wheel studs
K Fig 73. ( T E-120).
866030B
Fig 73.
9 Install the bearing support on the shaft. Take care
when passing the shaft through the lip seal
K Fig 74. ( T E-120).
866030C
Fig 74.
10 Install the bearing (074) in its outer race
K Fig 75. ( T E-120).
866030D
Fig 75.
11 Using a suitable mandrel, press the bearing onto the
shaft. Force required - 20000N (4500 lbf)
K Fig 76. ( T E-120).
866040A
Fig 76.
ðéí
ðéì