jcb Mini CX - Page 291

Section E - Hydraulics
Drive Motors
Wheel Drive Motors
E-121 E-121
9803-9340-8
12 Release the press force and rotate the bearing
support 5 turns to the right and left. Re-apply the
press force
K Fig 77. ( T E-121).
866040B
Fig 77.
13 Release the press force and install the thrust ring
(076)
K Fig 78. ( T E-121).
866040C
Fig 78.
14 Install the snap ring (077)
K Fig 79. ( T E-121).
866040D
Fig 79.
15 Re-apply the press force on the bearing then
measure the clearance between the thrust ring (076)
and the snap ring (077). Determine the shimming
required to achieve a rotational torque of 5 Nm (3.69
lbf ft)
K Fig 80. ( T E-121).
866050A
Fig 80.
16 Release the press force. Remove the snap ring and
thrust ring and install the shims. The thickest shim
should be mounted towards the bearing
K Fig 81. ( T E-122).
ðéê
ðéé