jcb Mini CX - Page 293

Section E - Hydraulics
Drive Motors
Wheel Drive Motors
E-123 E-123
9803-9340-8
866060D
Fig 86.
22 Visually check the correct position of the seal support
in the bearing support. Clean off excess sealant
K Fig 87. ( T E-123).
866070A
Fig 87.
23 Re-fit the lip seal spring K Fig 88. ( T E-123).
866070B
Fig 88.
24 Coat the external diameter of the back up ring support
with JCB Multigasket
K Fig 89. ( T E-123).
866070C
Fig 89.
25 Using a mandrel, install the back up ring support,
checking the correct mounting direction. Clean off
excess sealant
K Fig 90. ( T E-123).
866070D
Fig 90.
26 Install the ‘O’ ring
K Fig 91. ( T E-123).
866080A
Fig 91.