jcb Mini CX - Page 294

Section E - Hydraulics
Drive Motors
Wheel Drive Motors
E-124 E-124
9803-9340-8
27 Install the back-up ring K Fig 92. ( T E-124).
866080B
Fig 92.
28 Ensure that the ‘O’ ring groove is clean. Coat a new
‘O’ ring (027) with anti-oxidising grease and install in
the bearing support (071)
K Fig 93. ( T E-124).
866080C
Fig 93.
29 Coat a new ‘O’ ring (027) with anti-oxidising grease
and install in the valving cover (041)
K Fig 94. ( T E-124).
866080D
Fig 94.
30 Install the cam assembly (026) on the valving cover,
lining up the marks made during dismantling. The big
chamfers should be oriented towards the bearing
support. Centre the cam assembly using two screws
diametrically opposite
K Fig 95. ( T E-124).
866090A
Fig 95.
31 Install the bearing support using suitable lifting gear
K Fig 96. ( T E-124).
866090B
Fig 96.
ðîé
ðéï
ðìï
ðîê