JRC FF50 - Attaching Sensor to Bracket

Section 3 Installation
31
Do not position the sensor farther into the
water than necessary to avoid increasing
drag, spray, and water noise and reducing
boat speed.
CAUTION
➄
Using the vertical adjustment space on the bracket slots, slide the sensor up
or down to provide a projection of 1/8" (3mm). Tighten the screws (see
Figure 3-9).
Figure 3-8
Attaching the sensor to the bracket
retaining
cover
latch
pivot
arm (2)
Step 1 Step 2
Step 3 Step 4
slot (2)
Attaching the Sensor to the Bracket
①
If the retaining cover near the top of the bracket is closed, open it by
depressing the latch and rotating the cover downward (see Figure 3-8).
➁
Insert the sensor’s pivot arms into the slots near the top of the bracket.
➂ Maintain pressure until the pivot arms click into place.
➃
Rotate the sensor downward until the bottom snaps into the bracket.
➄
Close the retaining cover to prevent the accidental release of the sensor when
the boat is underway.