Chapter 4 MAINTENANCE
4.5 FAULT FINDING
4-22
Alarm name
(Japanese)
Alarm name
(English)
Class Description
操作中です
In Operation
Status This operation is disabled due to another operation
Setting enable/disable and class during alarm area
creation
Setting operations for on/off and floating position
during EBL bearing setting
Setting operations for on/off and bearing during EBL
floating position setting
Operations for on/off during VRM range setting
Operations for on/off, mode and saving during of
center custom position setting
Operations for PRF tuning during manual tuning
operations
Setting for automatic/manual mode during manual
tuning operations
Operations for manual tuning during PRF tuning
operation
方位/緯度経度 無し
No HDG/POSN Data
Status Cursor operations when own heading or latitude/longitude is
disabled
MOB input
Event mark input
Inputting/erasing/moving marks
Inputting/erasing/moving/inserting lines
Floating position setting for EBL latitude/longitude.
Floating position setting for VRM latitude/longitude.
Floating position setting for parallel cursor
latitude/longitude
AIS numerical display/destination ship/retrieved
vessel selection
Creating latitude/longitude alarm area.
TLL transmission for cursor.
できません
Not Allowed
Status
Operations for inserting by selecting the end point in
the line list.
Operations for switching to H-UP during TM
(When heading is not available, temporarily changed
to RM-HUp, therefore, message is disabled.)
設定不可なレンジです
Range Scale Limit
Status Operations functionally restricted for certain range.
Zoom operations in range where zoom is not
available.
Off center operations in range where off center is not
available.
TM setting operations in range where TM setting is
not available.
データがありません
No Valid Data
Status Operations without data.
Displaying history menu without history data.
Operations for editing/erasing in the mark list while
there is no mark.
Operations for editing/erasing/inserting in the line list
while there is no line.
To Next Page
Loading...
Need help?
General
