Chapter 2
OPERATIONS
2.7
SOFT KEY OPERATION
2-44
Reference:
y If a target with the mark “ۑ” is designated, only its true bearing and range will appear
until its vector appears.
y Tracking target data is displayed when the soft key 4 is set to "TT Detail" in the section
"2.7.11 SETTING DISPLAY SCREEN"
z Displaying tracking target data (Operation with the [ENT] key)
The target tracking data can be displayed by the [ENT] key operation without displaying
the soft key menu.
Note:
z If operating with the [ENT] key when the soft key menu is closed, the equipment
performs the followings:
On the AIS symbol: Opens the AIS soft key and the numerical display of AIS.
On the TT symbol: Opens the TT soft key and the numerical display of TT.
Not on the AIS or TT symbol:
Opens the TT soft key, it will be acquired.
z If operating with the [ENT] key when the AIS symbol overlaps the TT symbol,
the numerical display of AIS symbol takes priority.
1 Press the cursor keys to select the target for numerical display with the
cursor, then press the [ENT] key.
The selected target tracking numerical display is set, and the "TT" soft key is
displayed.
Reference:
After setting the TT numerical display, perform the same operations in "ە Displaying
tracking target data (Operation with the soft key menu)".
z Releasing tracking target data display
1 Press the cursor keys to select the target for the numerical display with the
cursor, then press the [ENT] key.
Numerical data display is released.
To Next Page
Loading...
Need help?
General
