Chapter 2 THE BASIC OPERATION
4
ە Photo frame settings
Note㸸This function is not currently implemented.
It will be supported in future by software version up.
Any image file can be set to the standby screen.
1. Put images in the USB “JMA-3400\IMAGE" folder beforehand.
2. Enter “77777” in the code input screen that appears
by long pressing the MENU button.
3. Photo frame display ON/OFF can be set.
Set ON to display the photo frame.
2.4.2 TRANSMISSION SCREEN
Starting transmission
Note:
࣭ Initial settings are required to display screens ղ to յ.
Refer to “8.9 SCREEN DISPLAY” for setting.
࣭ Even on the screens of ղ, ճ, մ, and յ above, transmission can be performed by
pressing the TX/PRF button.
Then press the STBY button, return to the standby screen that was displayed before the
TX/PRF button was pressed.
Press the TX/PRF button
Transmit
Example
To Next Page
Loading...
Need help?
General
