Juniper EX2300 Series - Page 116

NOTE: Do not block the vents on the top of EX2300-C switches. Blocking the vents can lead to
overheang of the switch chassis.
Ensure that you have the following parts and tools available:
• (Oponal and separately orderable; applies only to EX2300-C switches) 1 cable guard kit. The kit
includes the cable guard and 3 number-8 Phillips truss-head screws to secure the cable guard to the
EX2300-C switch
• (Oponal and separately orderable; applies only to EX2300-C switches) 1 standard cable lock kit to
secure the EX2300-C switch from the by connecng the cable to the security slot on the switch
and a desk or a rack to fasten the cable lock. The kit includes the standard cable lock and its key.
You can mount an EX2300 switch on a desk or other level surface by using the four rubber feet that are
preinstalled on the switch. The rubber feet stabilize the chassis.
To mount a switch on a desk or other level surface:
1. Remove the switch from the shipping carton (see "Unpacking an EX2300 Switch" on page 101).
2. (Oponal; applies only to EX2300-C switches) Aach the cable guard to protect cable connecons:
a. Use the 3 truss-head screws to aach the cable guard to the boom of the chassis.
b. Use the thumbscrews to ghten or loosen the cable guard so that you can insert cables. See
Figure 50 on page 107.
Figure 50: Aaching a Cable Guard to an EX2300-C Switch
1
— Cable guard 2— Thumb screws
107