Juniper EX2300 Series - Page 124

NOTE: The length of the mounng brackets depends on the switch model.
4. Align the boom holes in the mounng brackets with the holes on the side panels of the switch
chassis.
5. Insert the mounng screws into the aligned holes. Tighten the screws.
6. Ensure that the other holes in the mounng brackets are aligned with the holes in the side panels.
Insert a screw in each hole and ghten the screws.
7. Have one person grasp both sides of the switch, li the switch, and posion it in the rack, aligning
the mounng bracket holes with the threaded holes in the rack rail. Align the boom hole in each
mounng bracket with a hole in each rack rail, making sure the chassis is level. See Figure 57 on page
115.
Figure 57: Mounng the Switch on Two Posts of a Rack
8. Have a second person secure the switch to the rack by using the appropriate screws. Tighten the
screws.
9. Ensure that the switch chassis is level by verifying that all screws on one side of the rack are aligned
with the screws on the other side.
115