Juniper EX2300 Series - Page 87

Cable Specicaons
EX Series switches support SFP+ passive DAC cables. The passive Twinax cable is a straight cable with
no acve electronic components. EX Series switches support 1 m, 3 m, 5 m, and 7 m long SFP+
passive DAC cables. See Figure 49 on page 78.
Figure 49: SFP+ Direct Aach Copper Cables for EX Series Switches
The cables are hot-removable and hot-insertable: You can remove and replace them without powering
o the switch or disrupng switch funcons. A cable comprises a low-voltage cable assembly that
connects directly into two 10-Gigabit Ethernet ports, one at each end of the cable. The cables use high-
performance integrated duplex serial data links for bidireconal communicaon and are designed for
data rates of up to 10 Gbps.
List of DAC Cables Supported on EX Series Switches
For the list of DAC cables supported on EX Series switches and the specicaons of these cables, see:
• EX2300—Hardware Compability Tool page for EX2300
• EX3200—Hardware Compability Tool page for EX3200
• EX3300—Hardware Compability Tool page for EX3300
• EX3400—Hardware Compability Tool page for EX3400
• EX4200—Hardware Compability Tool page for EX4200
• EX4300—Hardware Compability Tool page for EX4300
• EX4400—Hardware Compability Tool page for EX4400
• EX4500—Hardware Compability Tool page for EX4500
• EX4550—Hardware Compability Tool page for EX4550
• EX4600—Hardware Compability Tool page for EX4600
78