Juniper QFX5240 - Disconnect a Fiber-Optic Cable

NOTE: Make sure to use a dust cap to cover ports that are unused.
NOTE: While using Finisar AOC SFP+ opcal module with the QFX5130-48C switch, you
may need to pull the module upwards to pull out the module smoothly from the cage.
NOTE: "
Figure 41: Install a Transceiver
1—
Ejector lever
Disconnect a Fiber-Opc Cable
Before you disconnect a ber-opc cable from an opcal transceiver, ensure that you have taken the
necessary precauons for safe handling of lasers. See Laser and LED Safety Guidelines and Warnings .
Ensure that you have the following parts and tools available:
• A rubber safety cap to cover the transceiver
• A rubber safety cap to cover the ber-opc cable connector
Juniper Networks devices have opcal transceivers to which you can connect ber-opc cables.
To disconnect a ber-opc cable from an opcal transceiver installed in the device:
106