Juniper QFX5240 - Maintain the Solid-State Drive in a QFX5240 Switch; Remove a Solid-State Drive from a QFX5240 Switch

NOTE: Each power supply must be connected to a dedicated power source outlet.
NOTE: If you have a Juniper Care service contract, register any addion, change, or upgrade of
hardware components at hps://www.juniper.net/customers/support/tools/updateinstallbase/ .
Failure to do so can result in signicant delays if you need replacement parts. This note does not
apply if you replace exisng components with the same type of component.
Maintain the Solid-State Drive in a QFX5240 Switch
IN THIS SECTION
Remove a Solid-State Drive from a QFX5240 Switch | 96
Install a Solid-State Drive in a QFX5240 Switch | 98
Remove a Solid-State Drive from a QFX5240 Switch
Before you remove a solid-state drive (SSD) from the device, ensure that you have taken the necessary
precauons to prevent electrostac discharge (ESD) damage.
Ensure that you have the following parts and tools available to remove a SSD from a QFX5240 switch:
• ESD grounding strap
• Anstac bag or an anstac mat
• Phillips (+) screwdriver, number 1
The QFX5240 supports two 480-GB NVMe SSDs. You cannot install or remove the SSDs when the
system is up. You must shut down the system before replacing the SSD. The SSDs are preinstalled in the
QFX5240.
1. Place the anstac bag or the anstac mat on a at, stable surface.
96