Juniper QFX5240 - QFX5240 Management Cable Specifications and Pinouts; Cable Specifications for Console and Management Connections for the QFX Series

QFX5240 Management Cable Specicaons and
Pinouts
IN THIS SECTION
Cable Specicaons for Console and Management Connecons for the QFX Series | 54
RJ-45 Management Port Connector Pinout Informaon | 55
Console Port Connector Pinouts for the QFX Series | 56
QSFP-DD Port Connector Pinout Informaon | 57
QSFP+, QSFP28, and QSFP56 Port Connector Pinout Informaon | 62
SFP, SFP+, and SFP28 Port Connector Pinout Informaon | 65
USB Port Specicaons for the QFX Series | 67
Cable Specicaons for Console and Management Connecons for the
QFX Series
Table 19 on page 54 lists the specicaons for the cables that connect the QFX Series switch to a
management device.
NOTE: The QFX Series can be congured with small form-factor pluggable (SFP) management
ports that support 1000BASE-SX transceivers. QFX5130 switches come with a RJ-45
management port, and support 10-Gbps speed. See the Hardware Compability Tool for more
informaon about the ber-opc cables required for use with these transceivers.
Table 19: Cable
Specicaons for Console and Management Connecons for the QFX Series
Port on QFX Series Device Cable Specicaon Maximum Length Device Receptacle
Console port RS-232 (EIA-232) serial cable 7 feet (2.13 meters) RJ-45
54