Juniper QFX5240 - Connect to Power

Connect to Power
IN THIS SECTION
Ground the QFX5240 Switch | 8
Connect the Power Cord and Power On the Switch | 9
This topic describes the steps to connect an AC-powered QFX5240 to power. To connect QFX5240 to
power, complete the following procedures:
Ground the QFX5240 Switch
To ground the QFX5240 switch, do the following:
1. Connect one end of the grounding cable to an appropriate earth ground site, such as the mounng
rack.
2. Remove the two M6 screws and star washers from the earthing terminal on the side of the chassis.
3. Place the Panduit LCDXN2-14AF-E or equivalent grounding lug aached to the grounding cable over
the protecve earthing terminal.
8