Juniper QFX5240 - Page 123

Table 27: Chassis Alarm Messages for QFX5240 (Connued)
Component Alarm Type CLI Message Recommended Acon
Temperature
sensors
Major (red)
FPC 0 Temperature Hot
Check environmental condions
and alarms on other devices. Ensure
that environmental factors (such as
hot air blowing around the
equipment) do not aect the
temperature sensor. If the condion
persists, the device might shut
down.
Minor (yellow)
FPC 0 Temperature Warm
Check environmental condions
and alarms on other devices. Ensure
that environmental factors (such as
hot air blowing around the
equipment) do not aect the
temperature sensor.
FPC 0 Temp Sensor Fail
Check the system log for the
following error message and report
the message to customer support:
Roung Engine Major (red)
RE RE number /var partition is full
File storage is at capacity. Reduce
unnecessary les to free space.
Minor (yellow)
RE RE number /var partition is high
File storage is reaching capacity.
Reduce unnecessary les to free
space.
Management
Ethernet
interface
Major (red)
Management interface management-
interface-name down on node
Check whether a cable is connected
to the management Ethernet
interface, or whether the cable is
defecve. Replace the cable, if
required.
116