10.5 Chassis
➤ Note the instructions in the separate documents:
■
"Chassis maintenance"
■ Chassis manufacturer's operating instructions
10.5.1 Wheel checks
Check the wheels and tires after the first 30 miles and after every wheel change, but at least every
six months for tightness, visible damage and tire pressures.
Material Torque wrench
Tire pressure gauge
Precondition The machine is switched off.
1. Wheel tightness check (see chapter 2.4.3 for torques)
2. Check the tires for any defect.
Replace any damaged or worn tires.
3. Check tire pressures (see chapter 2.4.2 for pressures).
10.5.2 Tow-bar maintenance
Clean and lubricate all sliding and rotating bearings as necessary but at least every 6 months.
Material Lithium enriched multi-purpose grease
Non-corroding oil
Cleaning rags
Precondition The machine is shut down.
The machine is disconnected from the towing vehicle and safely parked.
1. Check the tow-bar for correct function and movement.
Make sure the coupling is fully locked.
2. Clean and oil all sliding and rotating bearings.
The locking teeth on the tow-bar height adjustment joint are corroded and jammed and the
tow-bar height cannot be adjusted.
➤
If necessary, free the teeth by jerking the tow-bar horizontally and vertically.
➤ Clean the locking teeth and smear with water-repellent grease.
10.5.3 Overrun braking mechanism maintenance
Check and maintain the overrun braking mechanism according to the maintenance table.
Material Lithium-enriched multi-purpose grease
Acid-free oil
Cleaning cloth
Precondition The machine is shut down.
The machine is disconnected from the towing vehicle and safely parked.
10 Maintenance
10.5 Chassis
No.: 9_9446 01 USE
SERVICE MANUAL Screw Compressor
M26
99
To Next Page
Loading...
