Starting the machine and carrying out a trial run
1.
Start the machine and allow it to idle for about 1 minute.
2. Visually check the fuel system for leaks.
3. Shut down the machine.
4. Tighten all fittings.
10.3.4 Changing the engine oil
The engine oil should be changed:
■ according to the maintenance schedule,
■ according to the degree of contamination of the intake air,
■ at least once a year.
Material New engine oil, see chapter 2.6.4 for engine oil filling quantity.
Receptacle
Hose coupling
Cleaning cloth
Funnel
Precondition The machine is shut down.
The machine is standing level.
The machine is fully vented, the pressure gauge reads 0 psig.
Engine at operating temperature.
All compressed air consumers are disconnected and the air outlet valves are open.
The negative cable to the battery is disconnected.
Danger of burns from hot components and escaping engine oil!
➤ Wear long-sleeved clothing and gloves.
10 Maintenance
10.3 Engine
80
SERVICE MANUAL Screw Compressor
M26 No.: 9_9446 01 USE
To Next Page
Loading...
