KAESER M26 - Too Much Oil Residue in the Compressed Air; Oil Flows from the Compressor Air Filter after Shutdown; Tab. 54 Fault: too Much Oil Residue in the Compressed Air; Tab. 55 Fault: Oil Flows from the Compressor Air Filter after Shutdown

9.3.5 Too much oil residue in the compressed air
Possible cause Remedy Where can I get help?
Specialized
workshop
KAESER Ser‐
vice
Oil separator cartridge scavenge
line clogged.
Clean the strainer in the separa‐
tor cartridge dirt trap or have
changed if necessary.
– X
Fractured oil separator car‐
tridge.
Change, see chapter 10.4.5. – –
Oil level in the oil separator tank
too high.
Reduce to maximum level, see
chapters 10.4.1
and 10.4.3.
– –
Tab. 54 Fault: too much oil residue in the compressed air
9.3.6 Oil flows from the compressor air filter after shutdown
Possible cause Remedy Where can I get help?
Specialized
workshop
KAESER Ser‐
vice
Defective non-return function of
the inlet valve.
Repair or have replaced if nec‐
essary.
– X
Tab. 55 Fault: oil flows from the compressor air filter after shutdown
9 Fault Recognition and Rectification
9.3 Compressor faults and alarms
64
SERVICE MANUAL Screw Compressor
M26 No.: 9_9446 01 USE