Kamstrup MULTICAL 403 - Page 72

MULTICAL® 403
72
Kamstrup A/S · Technical description · FILE100000166_B_EN-55121689_M1_07.2023
The table below shows the parameters which can be changed via ”SETUP loop” and on the following pages each
parameter is explained in more detail.
Primary key
Index number in
display
1
Customer number (N
o
1)
3-001
2
Customer number (N
o
2)
3-002
3
Date
3-003
4
Time
1
3-004
5
Yearly target date 1 (MM.DD)
3-005
6
Monthly target date 1 (DD)
3-006
7
Flow sensor position: Inlet or outlet (A-code)
3-007
8
Measuring unit and resolution (B and CCC code)
(B and CCC-codes are configured as e.g. ”0,001 MWh” and ”0,01 m
3
”)
3-008
9
Primary address for module
3-009
10
Averaging period of min./max. P and Q
3-010
11
Heat/cooling shift (θ
hc
)
2
(Only active if meter type 6 is selected)
3-011
12
Temperature sensor offset (t
r0
)
3
3-012
13
Radio (on/off)
3-013
14
Input A (preset of register)
3-014
15
Input B (preset of register)
3-015
16
Meter number of Input A
3-016
17
Meter number of Input B
3-017
18
TL2
3-018
19
TL3
3-019
20
TL4
3-020
21
Preset of t5
3-021
22
”EndSetup”
3-022
1
In addition to adjusting the clock via ”SETUP loop”, the clock and the date can be changed via METERTOOL HCW and
via the modules too.
2
θ
hc
can only be changed in meters configured as meter type 6. In this meter type users can both change θ
hc
and
disable the function. If users attempt to access this menu in meters configured as other meter types, the message
”Off” is displayed.
3
This function can have been disabled via the selected country code.