MULTICAL® 403
Kamstrup A/S · Technical description · FILE100000166_B_EN-55121689_M1_07.2023
1. + 2 Customer no.
The customer number is a 16-digit figure distributed on two 8 digit menu points. The complete customer number
can be adjusted via the two menu points in ”SETUP loop”.
3. Date
The meter’s date can be adjusted in ”SETUP loop”. We recommend you to verify that the date was adjusted
correctly, especially if time was adjusted too.
4. Time
The meter’s time can be adjusted in ”SETUP loop”. We recommend you to verify that the time was adjusted
correctly, especially if the date was adjusted too.
5. Yearly target date 1
The meter’s yearly target date 1 can be adjusted in ”SETUP loop”. In MULTICAL® 403 yearly target date 2 can be
activated. This function is switched off by default, i.e. set at 00.00. If yearly target date 2 is active in a meter we
recommend that both yearly target dates are adjusted via METERTOOL HCW to ensure that they are correctly set
with respect to each other. Please note that activation of yearly target date 2 influences the depth of the yearly log
as the meter now makes two yearly loggings.
6. Monthly target date 1
The meter’s monthly target date 1 can be adjusted in ”SETUP loop”. In MULTICAL® 403 monthly target date 2 can be
activated. This function is switched off by default, i.e. set at 00. If monthly target date 2 is active in a meter we
recommend that both monthly target dates are adjusted via METERTOOL HCW to ensure that they are correctly set
with respect to each other. Please note that activation of monthly target date 2 influences the depth of the monthly
log as the meter now makes two monthly loggings.
To Next Page
Loading...
Need help?
General
