KaVo 3D eXam - Migrate from Standalone to Server

Kavo 3D eXam ® Operators’ Manual
K990400 16 April 2008
14-4
Migrate from Standalone to Server
NOTE:
•
Perform this procedure only if upgrading or migrating from
an existing standalone setup.
• If the existing network setup shares a portion of the local
disk of the VisionQ computer, it is still considered
standalone and this procedure should be followed.
1. Using the Sweeper controller, stop the Sweeper service if it is
running or paused.
2. Start VisionQ and reconstruct any scans that have not yet been
reconstructed.
a. Make a note of the standalone Image Root Folder name
using Tools > Setup. (It is probably C:\DATAFRAMES.)
Do not change the name at this time.
b. Exit VisionQ.