K990400 16 April 2008
Published by KaVo
KaVo reserves the right to make changes to both this Manual and to
the products it describes. Equipment specifications are subject to
change without notice. Nothing contained within this manual is
intended as any offer, warranty, promise or contractual condition,
and must not be taken as such.
This document may not, in whole or in Part, be copied, photocopied,
reproduced, translated, or reduced to any electronic medium or
machine-readable form without prior consent in writing from KaVo.
3D eXam
®
is a registered trademark KaVo. Other names may be
trademarks of their respective owners.
For more information or an original version of documentation on the
KaVo 3D eXam®, please write, call, or fax to KaVo. This
documentation has been drafted, approved & supplied in the English
Language. KaVo will make available under request any component
parts, calibration instruments, circuit diagrams, etc.
No part of this document may be reproduced or transmitted in any
form or by any means, electronic or mechanical, for any purpose,
without prior written permission of KaVo. The information in this
document and the product it describes are subject to change without
notice. Names and data used in examples herein are fictitious unless
otherwise noted. The software program described in this document
is provided to its users pursuant to a license or nondisclosure
agreement. Such software program may only be used, copied, or
reproduced pursuant to the terms of such agreement. This manual
does not contain or represent any commitment of any kind on the
part of KaVo.
To Next Page
Loading...