Model 2750 Multimeter/Switch System User’s Manual SCPI Reference Tables 15-15
[SENSe[1]]
:TEMPerature Path to configure temperature: Sec 3 ✓
:APERture <NRf>
[, <clist>]
Set integration rate in seconds (60Hz,
1.67e-4 to 1; 50Hz, 2e-4 to 1).
(Note 2) Sec 4
:APERture? [<clist>] Query aperture integration rate.
:NPLCycles <n>[, <clist>] Set integration rate in line cycles (60Hz,
0.01 to 60; 50Hz, 0.01 to 50).
5.0 Sec 4 ✓
:NPLCycles? Query line cycle integration rate. ✓
:DIGits <n> [, <clist>] Specify measurement resolution (4 to 7). 6 Sec 4
:DIGits? [<clist>] Query resolution.
:REFerence <n> [, <clist>] Specify reference in °C (-200 to 1820). 0 Sec 5 ✓
:STATe <b> [, <clist>] Enable or disable reference. OFF ✓
:STATe? [<clist>] Query state of reference. ✓
:ACQuire [, <clist>] Use input signal as reference.
:REFerence? [<clist>] Query reference value. ✓
:AVERage Path to configure and control filter: Sec 4
:TCONtrol <name> Select filter type: (MOVing or REPeat). (Note 3)
:TCONtrol? Query filter type.
:WINDow <NRf> Set filter window in % of range
(0 to 10).
0.1
:WINDow? Query filter window.
:COUNt <n> [, <clist>] Specify filter count (1 to 100). 10
:COUNt? [<clist>] Query filter count.
[:STATe] <b> [, <clist>] Enable or disable filter. (Note 4)
[:STATe]? [<clist>] Query state of digital filter.
:TRANsducer <name>
[, <clist>]
Select temperature transducer (TCouple,
FRTD, or THERmistor).
Sec 3
:TRANsducer? [<clist>] Query transducer type. TCouple
Table 15-5 (continued)
SENSe command summary
Command Description
Default
parameter Ref SCPI
2750-900-01.book Page 15 Wednesday, August 3, 2011 7:56 AM
To Next Page
Loading...
