Model 2750 Multimeter/Switch System User’s Manual SCPI Reference Tables 15-23
SYSTem
:RESet Reset reading number. Next reading will be #1.
:ERRor? Query (read) Error Queue. (Note 4) Sec 11 ✓
:CLEar Clears messages from the Error Queue. Sec 11
:VERSion? Query rev level of SCPI standard. Sec 14 ✓
:LOCal Take 2750 out of remote and restore operation of
front panel controls (RS-232 only).
Sec 10
:REMote Place 2750 in remote (RS-232 only). Sec 10
:RWLock Lockout front panel controls (RS-232 only). Sec 10
Note:
1. If there is no card in the specified slot, error -241 Hardware Missing will occur.
2. The Model 2700 uses a different syntax to specify a slot for the :CARD command. Instead of using the <NRF> parameter, the slot
number is included with the :CARD command word (i.e., SYST:CARD1:SNUM?). In order to make the Model 2750 compatible
with Model 2700 operation, the :CARD command for the Model 2750 will accept the syntax for slots 1 and 2.
3. If a pseudocard is installed in the slot, the message "????????" will be returned when querying the serial number or firmware
revision.
4. Power-up and *CLS clears the error queue.*RST, SYSTem:PRESet, and STATus:PRESet has no effect on the error queue.
Table 15-7 (continued)
SYSTem command summary
Command Description
Default
parameter Ref SCPI
2750-900-01.book Page 23 Wednesday, August 3, 2011 7:56 AM
To Next Page
Loading...
Need help?
General
