Introduction G-2
IEEE-488 bus configuration G-3
IEEE-488 Bus Overview G-1
IEEE-488 connector 10-5
IEEE-488.2 common commands and queries
12-2
IEEE-754 data formats 14-4
IEEE-754 single precision format 14-3
information
remote programming 1-25
inputs
front panel 1-11
INPUTs switch 1-11
Inspection 1-3
Interface function codes G-14
AH (Acceptor Handshake Function) G-14
C (Controller Function) G-15
DC (Device Clear Function) G-15
DT (Device Trigger Function) G-15
E (Bus Driver Type) G-15
L (Listener Function) G-14
LE (Extended Listener Function) G-15
PP (Parallel Poll Function) G-15
RL (Remote-Local Function) G-14
SH (Source Handshake Function) G-14
SR (Service Request Function) G-14
T (Talker Function) G-14
TE (Extended Talker Function) G-15
J
Johnson noise equation E-5
K
Keyclick 1-16
Remote programming 1-17
L
Line frequency 1-15
Line power connection 1-14
LOCAL key 10-11
Long-form and short-form versions 10-14
Low level considerations 3-12
AC voltage offset 3-13
Shielding 3-12
Thermal EMFs 3-13
lowest noise settings 4-8
LSYNC (line cycle synchronization) 3-5
M
Magnetic fields E-6
Manual Ranging 4-2
Manual/external trigger scan 7-22
Material thermoelectric coefficients E-2
Math 5-8
Basic operation 5-12
Scanning 5-12
commands 5-13
mX+b 5-9
mX+b configuration 5-9
mX+b rel 5-10
Percent 5-10
programming examples 5-15
Remote programming 5-13
Math commands
Percent reference 5-14
Reading math result 5-14
Setting mX+b units 5-14
MEASure:<function>? [<rang>], [<res>],
[<clist>] 13-7
Measurement capabilities 3-2
Measurement Considerations E-1, E-2
Measurement event register 11-13
Measurement event status 11-15
Measurement queries 3-50
:FETCh? 3-50
:MEASure[:<function>]? 3-51
:READ? 3-51
[:SENSe[1]]:DATA:FRESh? 3-52
[:SENSe[1]]:DATA[:LATest]? 3-52
Measurement ranges and maximum readings
4-2
Message exchange protocol 10-17
Meter loading E-10
Minimizing source resistance noise E-5
Minimizing thermal EMFs E-4
Miscellaneous SYSTem commands 14-7
Model 2750 curve fitting constants for
thermistors F-6
Model 7700 B-1
¾2-Wire and Thermistor connections B-8
¾4-Wire and RTD connections B-9
Connection Log B-10
Current connections (AC or DC) B-9
Module installation 2-3
Schematic diagram 2-35
Screw terminal channel designations B-6
simplified schematic 2-36
switching module 2-34, 3-8
Ratio and channel average
calculations 3-10
Thermocouple connections B-8
2750-900-01.book Page 4 Wednesday, August 3, 2011 7:56 AM
To Next Page
Loading...
