KERN DBS

commands to specify the serial number.
@SN = Serial Number
Serial numbers are specified using 10 or 12 alphanumeric characters.
5
.2.1 H
o
w to specif
y
the se
r
i
a
l No with
o
ut using a c
o
m
p
ute
r
Use the [EDIT] menu to edit NVRAM and specify the S/N setting. Replace each of digits of the serial
number to ASCII code using the following table. Set the ASCII code to the address 0044-004E. Set the
code "00" to the following address of the serial number.
46 DBS-SH-e-1210