KERN DBS User Manual

8.2
E
r
r
o
r
D
i
s
p
l
a
y
Failed to read from the EEPROM.
Measurement was attempted without pressing the [TARE] key.
(2) Temperature exceeded the setting value and increased rapidly (at least 15 °C per 10
value exceeded 2 % of the mass of the standard calibration weight.
Error No. Name Description
(Warning) OL Overload Weighing capacity is exceeded.
(Warning) -OL Underload Pan supporter is missing.
ERR. OL
Overload During
Measurement
Mass exceeded weighing capacity during measurement.
ERR. -OL
Underload During
Measurement
Pan supporter was removed during measurement.
ERR. 001
Mass Temperature Sensor
(TAD)
Open Circuit
Circuit broke in the mass temperature sensor.
ERR. 002
Mass Temperature Sensor
(TAD) Short Circuit
Short circuit occurred in the mass temperature sensor.
ERR. 005 EEPROM Data Error
Invalid value was written to the EEPROM.
ERR. 100 LidOpen1 Minute Error Lid was open for 1 minute or more during a measurement (when heated).
ERR. 101 Thermistor Open Circuit broke in the thermistor.
ERR. 102 Thermistor Short Shortcircuitoccurredinthe thermistor.
ERR. 110 Lid Switch Error Mass increased even though the lid is not open.
ERR. 111 TARE Error
Measurement was not started within 3 minutes of pressing the [TARE] key.
ERR. 121 Heater Failure
Temperature did not rise during measurements.
Starting temperature differential (difference between temperature when heating starts
and
temperature setting) was at least 60 degrees and temperature did not increase by
15 degrees within 30 seconds (5 degrees within 60 seconds in the slow
mode, however).
Decision is aborted if the lid is open before decision. Also, decision is aborted if
differential is
less than 60 degrees.
ERR. 122 Heater Error
Not during measurement (when heater is OFF)
(1) Sensor detected temperature rose (at least 20 ° Cper 10 sec).
During measurement
sec).
(3) Temperature increased after heating ended (at least 16 ° C per 10 sec).
ERR. 123 Heating Error Thermistor temperature exceeded 270 ° C
ERR. 124 ∆ M Error ∆ M did not reach the setting value foratleast4hours.
ERR. 200 Power Supply Error Power supply voltage range setting in CPU is inconsistent with the actual power supply.
ERR. 201 Unknown Frequency Error Power supply frequency could not be determined.
ERR. 202 Unknown Voltage Power supply voltage could not be determined.
COM. ERR Communications Error Unrecognized command was received during command reception.
ERR. C01 Instability Error Unstable state continued for at least 1 minute during mass calibration.
ERR. C04 Span Error
Difference between the measured span value and specified standard calibration weight
ABORT Abort
Moisture analyzer function was aborted.
58 DBS-SH-e-1210

KERN DBS Specifications

General

Brand	KERN
Model	DBS
Category	Measuring Instruments
Language	English