119
Keysight InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
9 Labels
To turn the label display on or off / 119
To assign a predefined label to a channel / 120
To define a new label / 121
To load a list of labels from a text file you create / 122
To reset the label library to the factory default / 123
You can define labels and assign them to each analog input channel, or you can
turn labels off to increase the waveform display area. Labels can also be applied to
digital channels on MSO models.
To turn the label display on or off
1 Press the [Label] key on the front panel.
This turns on labels for the displayed analog and digital channels. Labels are
displayed at the left edge of the displayed traces.
The figure below shows an example of displayed labels.
To Next Page
Loading...
Need help?
General
