Utility Settings 20
Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide 261
To perform front panel self test
Pressing [Utility] > Service > Front Panel Self Test lets you test the front panel keys
and knobs as well as the oscilloscope display.
Follow the on-screen instructions.
To display oscilloscope information
Press [Help] > About Oscilloscope to display information about your oscilloscope:
• Model number.
• Serial number.
•Bandwidth.
•Module installed.
•Software version.
• Installed licenses. See also “Loading Licenses and Displaying License
Information" on page 286.
To display the user calibration status
Pressing [Utility] > Service > User Cal Status displays the summary results of the
previous User Cal, and the status of probe calibrations for probes that can be
calibrated. Note that passive probes do not need to be calibrated.
Results:
User Cal date:
Change in temperature since last User Cal:
Failure:
Comments:
Probe Cal Status:
To clean the oscilloscope
1 Remove power from the instrument.
2 Clean the external surfaces of the oscilloscope with a soft cloth dampened with
a mixture of mild detergent and water.
3 Make sure that the instrument is completely dry before reconnecting it to a
power source.
To check warranty and extended services status
To learn the warranty status of your oscilloscope:
To Next Page
Loading...
Need help?
General
