85
Keysight InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
5 Reference Waveforms
To save a waveform to a reference waveform location / 85
To display a reference waveform / 86
To scale and position reference waveforms / 87
To adjust reference waveform skew / 87
To display reference waveform information / 88
To save/recall reference waveform files to/from a USB storage device / 88
Analog channel or math waveforms can be saved to one of two reference
waveform locations in the oscilloscope. Then, a reference waveform can be
displayed and compared against other waveforms. One reference waveform can
be displayed at a time.
When the multiplexed knobs are assigned to reference waveforms (this happens
when you press the [Ref] key and the LED to the left of it is lit), you can use the
knobs to scale and position reference waveforms. There is also a skew adjustment
for reference waveforms. Reference waveform scale, offset, and skew information
can optionally be included on the oscilloscope display.
Analog channel, math, or reference waveforms can be saved to a reference
waveform file on a USB storage device. You can recall a reference waveform file
from a USB storage device into one of the reference waveform locations.
To save a waveform to a reference waveform location
1 Press the [Ref] key to turn on reference waveforms.
2 In the Reference Waveform Menu, press the Ref softkey and turn the Entry knob
to select the desired reference waveform location.
3 Press the Source softkey and turn the Entry knob to select the source waveform.
To Next Page
Loading...
